> ## Knowledge Base Index
> Fetch the complete knowledge base index at: https://support.ntconnect.com/sitemap.xml
> Use this file to discover available pages before exploring further.
> Pure-Markdown content can be obtained by appending a '.md' suffix to the content URLs listed in the sitemap (without the trailing slash).

# Manual setup for your WiFi Network on your ezLINQ

* unplug ezLINQ and check sticker next to electrical plug

* write down or take a pic of the following: SSID, Passphrase, IP address, Username, Password

* Plug ezLINQ back in and connect the ezLINQ to the router with the ethernet cable

* wait until ezLINQ boots up and you can make a call

* Open a web browser from a computer

* Look for WiFi networks on your computer and connect to the NT Connect SSID broadcast which is the same 
as what is on the sticker. The wifi network will look something like this: netTALK-123456

* Once connected to that Wifi network, type in the IP address in to the browser. It will be something like: 192.168.11.1

* Then an ezLINQ web page will appear

* Enter the Username and Password found on the sticker. The Username is Admin and the password is 9 alpha numeric characters. 

* The navigate to the Wifi settings and setup setup the ezLINQ into 'Repeater Mode'


![](https://storage.crisp.chat/users/helpdesk/website/309e8a0a07431600/ezlinq_s8gwh0.jpg)