Articles on: IP Phone Configurations

Cisco SPA112

Cisco SPA112:



Cisco SPA112




STEP 1


You must first determine what IP address is assigned to your Cisco SPA112. To do this, you need to pick up the phone attached to the Line 1 jack and

dial: **** (four asterisks)

then dial: 110 #



and you will be told the IP address of your device (e.g. 192.168.0.100).


-


STEP 2

Go to any browser equipped computer on your network and enter the address:


http://<IP ADDRESS>/


(where <IP ADDRESS> is replaced by the address that was given to you in STEP 1.


-

STEP 3

Click on the "Quick Setup" button near the top left side of the screen.




-


STEP 4


You need to modify from the factory default. Settings needed:


Proxy: sip.nettalk.com

Display Name: Enter your full name, User ID or leave blank

User ID: Account Number provided on CONNECT

Password: Account SIP Password provided on CONNECT



SIP configuation


-


STEP 5


Click "Submit" at the bottom to save your changes. You will see the following screen:



Updated on: 09/14/2020

Was this article helpful?

Share your feedback

Cancel

Thank you!